1 Roberge Close, St. Albert
Lot Address
1 Roberge Close
St. Albert, Alberta
Riverside 1A-1B
Block 1, Lot 72
152 5301
St. Albert, Alberta
Riverside 1A-1B
Block 1, Lot 72
152 5301
Approval Agent
Requester Contact
Ironstone Home Builders
LEED Program Status Set to: LEED Certified
Wahid Moshfegh
Can you please confirm that your recycling rate is 100% meaning no waste was landfilled?
- Letter Stating how waste is handled.
Can you confirm that the fireplace is either EPA certified or meets the CSA B 415 standard?
- See attached SL-550TRS
Do you have anything else that shows the type of bulbs installed, the receipt does not show that they are LED or CFL as far as I can tell.
- No all bulbs were changed prior to possession.
Do you have anything showing that at least 90% of the insulation and drywall was extracted and manufactured within 800kms from the project site? The document you sent does not state exactly where the product was harvested from as well as manufactured.
- Insulation is local from Edmonton Planet. Drywall looks like it is not.
You did not send any information on the VOC amounts of any adhesives and sealants used on site (such as PL etc.)
- no PL used. Sealants sent
Can you also provide the room by room load calculations as well as the MERV value of the filter(s)?
- See attached. Merv filters installed by Weisse Johnson
Can you please provide the documentation showing the flow rates of the toilet, shower and bathroom taps?
- See attached
Files Attached:
Rear ElevationSide Elevation |
Approved Materials & Colors
|
Approving Authority
Approval Agents
Requester
Reset
00:00:00hr | min | sec
Kaitlyn Allcock-D'silva
Can you please confirm that your recycling rate is 100% meaning no waste was landfilled?
Can you confirm that the fireplace is either EPA certified or meets the CSA B 415 standard?
Do you have anything else that shows the type of bulbs installed, the receipt does not show that they are LED or CFL as far as I can tell.
Do you have anything showing that at least 90% of the insulation and drywall was extracted and manufactured within 800kms from the project site? The document you sent does not state exactly where the product was harvested from as well as manufactured.
You did not send any information on the VOC amounts of any adhesives and sealants used on site (such as PL etc.)
Can you also provide the room by room load calculations as well as the MERV value of the filter(s)?
Can you please provide the documentation showing the flow rates of the toilet, shower and bathroom taps?
May 15th 2017 4:17pm By: Kaitlyn Allcock-D'silva, EcoAmmo
stephen.gomori@streetscape.ai